# 15mm error while running code

**URL:** <https://forums.maslowcnc.com/t/15mm-error-while-running-code/21106>\
**Category:** Uncategorized\
**Created:** [May 19, 2024, 5:56pm UTC](https://forums.maslowcnc.com/t/15mm-error-while-running-code/21106 "2024-05-19T17:56:08Z")\
**Posts on this page:** 1\
**Showing post:** 166

<div class="post-metadata">

**Author:** ![willemx](https://avatars.discourse-cdn.com/v4/letter/w/a4c791/32.png) [@willemx](https://forums.maslowcnc.com/u/willemx)\
**Post date:** [July 5, 2024, 3:12pm UTC](https://forums.maslowcnc.com/t/15mm-error-while-running-code/21106/166 "2024-07-05T15:12:11Z")

</div>

Another test: I tried grounding my sled with a copper wire:

 ![image](https://canada1.discourse-cdn.com/flex031/uploads/maslowcnc/original/3X/5/5/55fd03790c70b89e9b4c65d6491b6f7fd4e932a1.jpeg)  
 ![image](https://canada1.discourse-cdn.com/flex031/uploads/maslowcnc/original/3X/3/d/3d9e202fd07f80759307d892358bdbce7dab0e8d.jpeg)  
The wire is attached to the sled with 4 self tapping screws and runs across the plexiglass cover and is wrapped around the dust collector. It is connected to mains ground using a standard mains plug (don’t worry about the blue and brown wires, they are both connected to the ground/earth pin).  
I ran the same test cut that had always failed, but now it succeeded (I ran the test 4 times, router cutting and dust collection on).  
BTW, I also replaced the standard CAT6 cables with longer ones (50 cm). I think the standard cables are a bit short and rigid, causing the RJ45 connectors to wiggle in their sockets when the motor arms are rotating.  
 ![image](https://canada1.discourse-cdn.com/flex031/uploads/maslowcnc/original/3X/5/0/50de3dd9966022bd369412027cbd1c0316b03d14.jpeg)  
With the longer cables, the connectors move a lot less and I haven’t seen anymore connection problems.

---

_[View the full topic](https://forums.maslowcnc.com/t/15mm-error-while-running-code/21106)._
