# 4.1 Calibration Initial Fitness

**URL:** <https://forums.maslowcnc.com/t/4-1-calibration-initial-fitness/23950>\
**Category:** Troubleshooting\
**Created:** [April 29, 2025, 4:29pm UTC](https://forums.maslowcnc.com/t/4-1-calibration-initial-fitness/23950 "2025-04-29T16:29:05Z")\
**Posts on this page:** 1\
**Showing post:** 2

<div class="post-metadata">

**Author:** ![bar](https://yyz1.discourse-cdn.com/flex031/user_avatar/forums.maslowcnc.com/bar/32/10_2.png) [@bar](https://forums.maslowcnc.com/u/bar)\
**Post date:** [April 29, 2025, 4:51pm UTC](https://forums.maslowcnc.com/t/4-1-calibration-initial-fitness/23950/2 "2025-04-29T16:51:30Z")

</div>

A couple of things stand out to me:

From the log I can get your measurements:

CLBM:[{bl:2045.40, br:2099.78, tr:2313.16, tl:2301.12},{bl:2192.73, br:1971.75, tr:2200.15, tl:2412.66},{bl:2266.99, br:2046.11, tr:2106.11, tl:2338.21},{bl:2174.65, br:2168.40, tr:2194.25, tl:2215.47},{bl:2049.89, br:2293.30, tr:2320.18, tl:2094.61},{bl:1966.39, br:2231.56, tr:2401.76, tl:2172.57},]

Plugging those into the simulator to see if anything looks off, it looks like it’s just your first measurement which is throwing things off. If I remove the first measurement then everything looks good:

 ![image](https://canada1.discourse-cdn.com/flex031/uploads/maslowcnc/original/3X/8/5/85350d1bb415549806700424a6429ac7babb255d.jpeg)

I think that the number one thing to do is to hang tight until I finish filming the walk-through video of the calibration process. I think that if you follow along with the steps that I usually do it’s going to fix that issue with the first measurement.

Re the video where the machine turned off. I didn’t realize that you had the 4.1 upgrade installed. I think I got confused about who had what setup in that other thread because there was a lot going on.

The first thing that comes to mind is this issue:

> [@Solution for disconnect and board wont start problem!](https://forums.maslowcnc.com/t/solution-for-disconnect-and-board-wont-start-problem/23871):
>
> Hello all, TLDR: Clip the thru pins on the encoders JST-HX headers. It will save your headaches. I had an issue after initial assembly where my control board didn’t indicate it had power even when plugged in. Power supply was fine and some of the components got hot but it wouldn’t start up. Thinking it was a control board issue after troubleshooting I received a replacement board and i checked it before assembly and it started up just fine. After installation I plugged in the power and… Nothin…

Does that match the behavior you saw?

---

_[View the full topic](https://forums.maslowcnc.com/t/4-1-calibration-initial-fitness/23950)._
