# Accuracy problems

**URL:** <https://forums.maslowcnc.com/t/accuracy-problems/21608>\
**Category:** Troubleshooting\
**Created:** [June 21, 2024, 10:46pm UTC](https://forums.maslowcnc.com/t/accuracy-problems/21608 "2024-06-21T22:46:55Z")\
**Posts on this page:** 1\
**Showing post:** 11

<div class="post-metadata">

**Author:** ![jwolter](https://yyz1.discourse-cdn.com/flex031/user_avatar/forums.maslowcnc.com/jwolter/32/30787_2.png) [@jwolter](https://forums.maslowcnc.com/u/jwolter)\
**Post date:** [June 27, 2024, 1:30am UTC](https://forums.maslowcnc.com/t/accuracy-problems/21608/11 "2024-06-27T01:30:11Z")

</div>

Look in the settings for fractal mode and turn it off. 😅

Sorry, I couldn’t resist. I’m assuming those extra arcs were not what you intended. My guess is that is something 1) in the gcode, or 2) how the Maslow interprets the gcode. There was a discussion recently about some unwanted behavior when using a certain arc command. I bet you found that. [M4 crashes whilst trying to cut gcode](https://forums.maslowcnc.com/t/m4-crashes-whilst-trying-to-cut-gcode/21344)

---

_[View the full topic](https://forums.maslowcnc.com/t/accuracy-problems/21608)._