# All rollers have magnets

**URL:** <https://forums.maslowcnc.com/t/all-rollers-have-magnets/25823>\
**Category:** Troubleshooting\
**Created:** [May 30, 2026, 5:16pm UTC](https://forums.maslowcnc.com/t/all-rollers-have-magnets/25823 "2026-05-30T17:16:00Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![Toomin](https://avatars.discourse-cdn.com/v4/letter/t/85e7bf/32.png) [@Toomin](https://forums.maslowcnc.com/u/Toomin)\
**Post date:** [May 30, 2026, 5:16pm UTC](https://forums.maslowcnc.com/t/all-rollers-have-magnets/25823/1 "2026-05-30T17:16:00Z")

</div>

I just picked up my 4.1 kit and all 8 rollers have magnets preinstalled. Should I face the extra magnets away from the encoder board to keep them far from the sensor?

---

<div class="post-metadata">

**Author:** ![ian\_ab](https://avatars.discourse-cdn.com/v4/letter/i/a587f6/32.png) [@ian\_ab](https://forums.maslowcnc.com/u/ian_ab)\
**Post date:** [May 30, 2026, 9:05pm UTC](https://forums.maslowcnc.com/t/all-rollers-have-magnets/25823/2 "2026-05-30T21:05:45Z")

</div>

I don’t think it would matter, but it won’t hurt. Just so the magnet end next to the sensor is correct.

---

<div class="post-metadata">

**Author:** ![bar](https://yyz1.discourse-cdn.com/flex031/user_avatar/forums.maslowcnc.com/bar/32/10_2.png) [@bar](https://forums.maslowcnc.com/u/bar)\
**Post date:** [June 1, 2026, 7:00pm UTC](https://forums.maslowcnc.com/t/all-rollers-have-magnets/25823/3 "2026-06-01T19:00:18Z")

</div>

Woah, that’s a first! I’m sorry about that!

You can rotate them to be away from the sensor, you can also pop out the extra magnets using the Allen wrench to push them out from the other side.