# Broken Plastic Parts

**URL:** <https://forums.maslowcnc.com/t/broken-plastic-parts/25542>\
**Category:** Troubleshooting\
**Created:** [February 22, 2026, 9:19pm UTC](https://forums.maslowcnc.com/t/broken-plastic-parts/25542 "2026-02-22T21:19:00Z")\
**Posts on this page:** 1\
**Showing post:** 2

<div class="post-metadata">

**Author:** ![ian\_ab](https://avatars.discourse-cdn.com/v4/letter/i/a587f6/32.png) [@ian\_ab](https://forums.maslowcnc.com/u/ian_ab)\
**Post date:** [February 22, 2026, 9:50pm UTC](https://forums.maslowcnc.com/t/broken-plastic-parts/25542/2 "2026-02-22T21:50:22Z")

</div>

Have a look at

> [@Maslow 4 3D printed parts thread](https://forums.maslowcnc.com/t/maslow-4-3d-printed-parts-thread/20627):
>
> Making this thread to collect all 3D printed accessories for the Maslow 4. My store for 3D printed parts: [Jax3Dprints.com](http://Jax3Dprints.com) If theres something you want, that you don’t see. Just reach out to me! slight_smile

There are a number of parts ready to print. Recommend the Turtle Clamp.

> [@Turtle Clamp (non-split clamp design)](https://forums.maslowcnc.com/t/turtle-clamp-non-split-clamp-design/25420):
>
> Why turtle clamp? Fresh off the printer, the cutout looks like a turtle to me: Files here: Intro Stiffness of the clamps is something that I’ve been keen on improving for a while. I touched on it a bit as part of my [I linear rails-ed my Maslow](https://forums.maslowcnc.com/t/i-linear-rails-ed-my-maslow/24987) build. 20mm thick clamps seemed like an obvious place to start and gave me a significant improvement, but there was a lot more I wanted to do. This is what I came up with: There were a few points I wanted to address: No split in…

---

_[View the full topic](https://forums.maslowcnc.com/t/broken-plastic-parts/25542)._