# Building a Bolger Bobcat (Payson Tiny Cat) catboat from CAD on up **URL:** \ **Category:** Projects\ **Created:** [January 10, 2018, 9:31pm UTC](https://forums.maslowcnc.com/t/building-a-bolger-bobcat-payson-tiny-cat-catboat-from-cad-on-up/1851 "2018-01-10T21:31:28Z")\ **Posts on this page:** 1\ **Showing post:** 95
**Author:** ![MidnightMaker](https://yyz1.discourse-cdn.com/flex031/user_avatar/forums.maslowcnc.com/midnightmaker/32/2397_2.png) [@MidnightMaker](https://forums.maslowcnc.com/u/MidnightMaker)\ **Post date:** [August 1, 2018, 3:08pm UTC](https://forums.maslowcnc.com/t/building-a-bolger-bobcat-payson-tiny-cat-catboat-from-cad-on-up/1851/95 "2018-08-01T15:08:16Z")
Make sure to check out the thread below if you haven’t already. I actually love the lofting process, but you’re right, there’s a lot of pressure to make the parts in the nesting diagram actually fit on the sheet. A few months ago, I had to make six planks fit onto a 12’ scarfed sheet. I actually worried about it the entire previous night and it actually took some gumption to go into the shop that morning to begin. I kept checking and re-checking the measurements. On the second to last plank, I finally knew they were all going to fit. I ended up having 2" to spare across the 48" I started with. Whew! 🕶 What boat(s) are you interested in? Would love to discuss it over here: > [@Boat Builders Projects](https://forums.maslowcnc.com/t/boat-builders-projects/2536): > > There was a suggestion to start a thread for all the boat builders - So here it is. If your building a boat tell us about it here. --- _[View the full topic](https://forums.maslowcnc.com/t/building-a-bolger-bobcat-payson-tiny-cat-catboat-from-cad-on-up/1851)._