# Can't Find Anchors, Can't get out of Extended Mode

**URL:** <https://forums.maslowcnc.com/t/cant-find-anchors-cant-get-out-of-extended-mode/25771>\
**Category:** Troubleshooting\
**Created:** [May 13, 2026, 1:57pm UTC](https://forums.maslowcnc.com/t/cant-find-anchors-cant-get-out-of-extended-mode/25771 "2026-05-13T13:57:08Z")\
**Posts on this page:** 1\
**Showing post:** 2

<div class="post-metadata">

**Author:** ![bar](https://yyz1.discourse-cdn.com/flex031/user_avatar/forums.maslowcnc.com/bar/32/10_2.png) [@bar](https://forums.maslowcnc.com/u/bar)\
**Post date:** [May 13, 2026, 6:18pm UTC](https://forums.maslowcnc.com/t/cant-find-anchors-cant-get-out-of-extended-mode/25771/2 "2026-05-13T18:18:49Z")

</div>

It looks to me like you are _RIGHT_ at the edge of where things will pass…like incredibly close, like .013mm off. That is 1/10th of a piece of paper thickness which is crazy.

```auto
[MSG:INFO: Center point deviation: TL: 4.117 TR: 3.182 BL: 8.510 BR: 12.013]
[MSG:ERR: Center point deviation over 12.000mm, your coordinate system is not accurate, maybe try running Find Anchors again?]

```

This also seems respectable, but just below the threshold.

```auto
Best fitness achieved: 0.4200401
Updating initial frame size with best estimate from all attempts.

```

This answer could also apply to you:

> [@One more try then I am giving up](https://forums.maslowcnc.com/t/one-more-try-then-i-am-giving-up/25770/4):
>
> If you are frustrated and just want things to work you can lower that threshold in settings.
> 
> ![image](https://canada1.discourse-cdn.com/flex031/uploads/maslowcnc/original/3X/3/6/360457f777afd6f607f5d003c7f723c0bce7957b.png)
> 
> ![image](https://canada1.discourse-cdn.com/flex031/uploads/maslowcnc/original/3X/3/7/371c22064a3f09430cffb7613b3570bc3880aea5.png)
> 
> Try lowering that setting to something lower like 0.3 and it should pass.

---

_[View the full topic](https://forums.maslowcnc.com/t/cant-find-anchors-cant-get-out-of-extended-mode/25771)._