# Cant update to Holey Firmware, and cant get the software to run outside of Docker

**URL:** <https://forums.maslowcnc.com/t/cant-update-to-holey-firmware-and-cant-get-the-software-to-run-outside-of-docker/24062>\
**Category:** Troubleshooting\
**Created:** [May 8, 2025, 10:21pm UTC](https://forums.maslowcnc.com/t/cant-update-to-holey-firmware-and-cant-get-the-software-to-run-outside-of-docker/24062 "2025-05-08T22:21:14Z")\
**Posts on this page:** 1\
**Showing post:** 8

<div class="post-metadata">

**Author:** ![TimS](https://yyz1.discourse-cdn.com/flex031/user_avatar/forums.maslowcnc.com/tims/32/17329_2.png) [@TimS](https://forums.maslowcnc.com/u/TimS)\
**Post date:** [May 23, 2025, 12:42am UTC](https://forums.maslowcnc.com/t/cant-update-to-holey-firmware-and-cant-get-the-software-to-run-outside-of-docker/24062/8 "2025-05-23T00:42:40Z")

</div>

The flash button in webcontrol flashes what ever file is in that folder location, ensure its the right hex file for your firmware.

Do you have the original shield? I’ve tried Orobs forks and they worked but there was some bugs, don’t know if they got sorted. I went back to .94, the link can be found in the wiki below. (I’m not sure if .94 will support the Eastbay board)

Here is this wiki, it might help.

> [@WebControl: how to use the basic and advanced features](https://forums.maslowcnc.com/t/webcontrol-how-to-use-the-basic-and-advanced-features/13241/5):
>
> Pinned slight_smile

---

_[View the full topic](https://forums.maslowcnc.com/t/cant-update-to-holey-firmware-and-cant-get-the-software-to-run-outside-of-docker/24062)._