On a range from 1-100 this is near the 100 for stupid quesitons.
If I hit “ceck for chain slip” should I expect the sled to return to the points I set at restart
(sprokets vertical, chain marks over the vertical position)?
Webcontrol - V94
Pi4
To close my own quesition~
When the machine is working. That button does send it back to the “Ive put the chains on the mark” place. It appears I just had a dudd motor
I’m new to actually cutting things now, but run that to check I didn’t skip a tooth, just as a sanity check. Paint marks do line up.