# Cut Tolerance Specifications
**URL:** https://forums.maslowcnc.com/t/cut-tolerance-specifications/8262
**Category:** Technical Details
**Created:** [December 28, 2018, 4:42pm UTC](https://forums.maslowcnc.com/t/cut-tolerance-specifications/8262 "2018-12-28T16:42:30Z")
**Posts on this page:** 4
**Page:** 1
### Author:  [@Marcum81](https://forums.maslowcnc.com/u/Marcum81)
#### Post date: [December 28, 2018, 4:42pm UTC](https://forums.maslowcnc.com/t/cut-tolerance-specifications/8262/1 "2018-12-28T16:42:31Z")
Hello All,
Does anyone know how tight a tolerance this can hold?
---
### Author:  [@madgrizzle](https://forums.maslowcnc.com/u/madgrizzle)
#### Post date: [December 28, 2018, 4:58pm UTC](https://forums.maslowcnc.com/t/cut-tolerance-specifications/8262/2 "2018-12-28T16:58:22Z")
Maslow is very precise (not sure it’s been quantified but it’s quite impressive). However, accuracy varies greatly depending upon how well the end user builds and calibrates it. The goal is 0.5 mm accuracy but I suspect most people see around 1mm or so. Lots of factors affect accuracy that don’t affect precision.
I’m not sure that answers your question.
---
### Author:  [@dlang](https://forums.maslowcnc.com/u/dlang)
#### Post date: [December 29, 2018, 3:46am UTC](https://forums.maslowcnc.com/t/cut-tolerance-specifications/8262/3 "2018-12-29T03:46:24Z")
rephrasing this
repeatability is _very_ good, having the measurements match a tape measure, not
quite as good.
many people get it to ithin 1/8" a few have bettered 1/16", the goal is 1/64"
but we are not there, mostly due to software limits.
---
### Author:  [@Marcum81](https://forums.maslowcnc.com/u/Marcum81)
#### Post date: [January 2, 2019, 3:03pm UTC](https://forums.maslowcnc.com/t/cut-tolerance-specifications/8262/4 "2019-01-02T15:03:32Z")
Thank you for the information! 1/8" is good enough for us!