# Cutting question

**URL:** <https://forums.maslowcnc.com/t/cutting-question/6866>\
**Category:** No Judgement\
**Created:** [September 21, 2018, 9:48pm UTC](https://forums.maslowcnc.com/t/cutting-question/6866 "2018-09-21T21:48:31Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![trynna](https://avatars.discourse-cdn.com/v4/letter/t/c68b51/32.png) [@trynna](https://forums.maslowcnc.com/u/trynna)\
**Post date:** [September 21, 2018, 9:48pm UTC](https://forums.maslowcnc.com/t/cutting-question/6866/1 "2018-09-21T21:48:31Z")

</div>

I am trying to find out how to change the cut? when i did my first try i just used the marker to let it draw on my board to make sure it looked correct, but its going around each cutout in the letters 6 times and the full outline 6 times? i dont have the z axis installed yet so it just keeps popping a window up to move the z axis to -25 then -39 then -50 and so on. do i have to do this many cuts?  
i am using the 4x8 3/4 inch birchwood?

---

<div class="post-metadata">

**Author:** ![dlang](https://yyz1.discourse-cdn.com/flex031/user_avatar/forums.maslowcnc.com/dlang/32/859_2.png) [@dlang](https://forums.maslowcnc.com/u/dlang)\
**Post date:** [September 21, 2018, 9:02pm UTC](https://forums.maslowcnc.com/t/cutting-question/6866/2 "2018-09-21T21:02:28Z")

</div>

the cut is fully controlled by the g-code.

you are seeing why the Z axis is considered mandatory 🙂

without knowing what you are cutting, it’s impossible to know if that number of  
Z changes is appropriate, we do know that makercam does far more Z changes than  
is really needed.

the number of passes is determined by how deep you cut in each pass, depending  
on who you read, reasonable values are from 1/2 bit diameter to 2x bit diameter  
per pass.

David Lang

---

<div class="post-metadata">

**Author:** ![jwolter](https://yyz1.discourse-cdn.com/flex031/user_avatar/forums.maslowcnc.com/jwolter/32/30787_2.png) [@jwolter](https://forums.maslowcnc.com/u/jwolter)\
**Post date:** [September 22, 2018, 1:11pm UTC](https://forums.maslowcnc.com/t/cutting-question/6866/3 "2018-09-22T13:11:00Z")

</div>

The number of passes depends on both the depth of each pass and the thickness of your material and/or depth of the pockets being cut. You should be able to control this in the program that generates your g-code. How deep you make your passes is somewhat of an art, but yes, it will probably take several passes to cut through 3/4" plywood.
