# Dialing in Maslow's accuracy

**URL:** <https://forums.maslowcnc.com/t/dialing-in-maslows-accuracy/6019>\
**Category:** Troubleshooting\
**Tags:** accuracy\
**Created:** [August 21, 2018, 12:53am UTC](https://forums.maslowcnc.com/t/dialing-in-maslows-accuracy/6019 "2018-08-21T00:53:17Z")\
**Posts on this page:** 1\
**Showing post:** 2

<div class="post-metadata">

**Author:** ![Dustcloud](https://yyz1.discourse-cdn.com/flex031/user_avatar/forums.maslowcnc.com/dustcloud/32/1786_2.png) [@Dustcloud](https://forums.maslowcnc.com/u/Dustcloud)\
**Post date:** [August 21, 2018, 1:15am UTC](https://forums.maslowcnc.com/t/dialing-in-maslows-accuracy/6019/2 "2018-08-21T01:15:18Z")

</div>

Yes you are moving in the right direction… a lot has been written on this subject… check out the following:

> [@Let’s dial it in!](https://forums.maslowcnc.com/t/let-s-dial-it-in/4681):
>
> Just got my maslow set up. My 18” sled circle is 18 by 17.75 I know this is not a huge deal but I’d like to dial it in. All help is appreciated.

Also, to gain a better understanding about how all this works, check the following:

> [@Accuracy Issues](https://forums.maslowcnc.com/t/accuracy-issues/5855):
>
> Definition and the Calibration Model It’s important to make sure you use the correct language when describing your issues and the definitions of accuracy and precision are often confused. Accuracy is how close a measured value is to a desired value. You want to cut a 12-inch square and you get an 11-inch square, you accuracy is poor. Precision is how close multiple measured values are. You want to cut a 12-inch square and do so in 5 passes around the plywood and each cut perfectly overlaps t…

Hang in there! We are all in the same boat!

---

_[View the full topic](https://forums.maslowcnc.com/t/dialing-in-maslows-accuracy/6019)._
