# Dust collection manifold sizes

**URL:** <https://forums.maslowcnc.com/t/dust-collection-manifold-sizes/21245>\
**Category:** Hardware\
**Created:** [May 27, 2024, 4:09pm UTC](https://forums.maslowcnc.com/t/dust-collection-manifold-sizes/21245 "2024-05-27T16:09:36Z")\
**Posts on this page:** 1\
**Page:** 1

<div class="post-metadata">

**Author:** ![VetterTech](https://yyz1.discourse-cdn.com/flex031/user_avatar/forums.maslowcnc.com/vettertech/32/24576_2.png) [@VetterTech](https://forums.maslowcnc.com/u/VetterTech)\
**Post date:** [May 27, 2024, 4:09pm UTC](https://forums.maslowcnc.com/t/dust-collection-manifold-sizes/21245/1 "2024-05-27T16:09:36Z")

</div>

I realized that the dust collection manifolds in the [The Not Shop — Maslow](https://www.maslowcnc.com/the-not-shop) are listed by OD. Our Bosch fits the 40mm (Green Tool) with its male hose end adapter. I cleaned out the inside of the hole with a 35mm Forstner bit to remove print flashing and supports. I printed in PLA and hoping it holds up. 35% infill and supports set support at 65 degrees.