# Error Message that Sled is not Keeping Up **URL:** \ **Category:** Troubleshooting\ **Created:** [November 19, 2018, 6:25pm UTC](https://forums.maslowcnc.com/t/error-message-that-sled-is-not-keeping-up/7765 "2018-11-19T18:25:24Z")\ **Posts on this page:** 1\ **Showing post:** 23
**Author:** ![Sreenigne](https://avatars.discourse-cdn.com/v4/letter/s/c77e96/32.png) [@Sreenigne](https://forums.maslowcnc.com/u/Sreenigne)\ **Post date:** [November 21, 2018, 6:34pm UTC](https://forums.maslowcnc.com/t/error-message-that-sled-is-not-keeping-up/7765/23 "2018-11-21T18:34:37Z")
This is so very similar to my problems. When my motor test fails (direction 1) it makes a series of beeps (sounds not sure if they are beeps), then moves to the other rotation direction. I am going to try and get a recording of it tonight also and upload to my posting. Any help you all can give to my situation would also be appreciated. @blurfl has been most helpful already in identifying issues with the firmware and my Gcode. > [@HELP ME Maslow Wizards](https://forums.maslowcnc.com/t/help-me-maslow-wizards/7767): > > I need help. My system has been running and stable for a while. I just completed the Meticulous Z upgrades and all was running well until two days ago. Not sure how to classify or summarize my problems more concise then the following. My system was running, in the middle of a program (cutting a simple circle near the middle/right side of the sheet about 12" from top of sheet), when it just stopped moving. I received the dreaded sled not keeping up warning. I am happy I was closely watching or … --- _[View the full topic](https://forums.maslowcnc.com/t/error-message-that-sled-is-not-keeping-up/7765)._