# Fail of the Week

**URL:** <https://forums.maslowcnc.com/t/fail-of-the-week/20742>\
**Category:** Projects\
**Created:** [April 20, 2024, 9:30pm UTC](https://forums.maslowcnc.com/t/fail-of-the-week/20742 "2024-04-20T21:30:34Z")\
**Posts on this page:** 1\
**Showing post:** 23

<div class="post-metadata">

**Author:** ![Jeremiad](https://avatars.discourse-cdn.com/v4/letter/j/13edae/32.png) [@Jeremiad](https://forums.maslowcnc.com/u/Jeremiad)\
**Post date:** [November 29, 2024, 4:57pm UTC](https://forums.maslowcnc.com/t/fail-of-the-week/20742/23 "2024-11-29T16:57:03Z")

</div>

I did not do this carve on a Maslow. It was done on a FoxAlien Masuter 4040 (gantry) machine, which is a lot different of a machine. That’s not to say that the Maslow can’t do it, because it sure can, but the feed and speed could be very different.

I settled in at about 300mm/m and depth at 0.6mm.

Once I get a couple other projects off the frame, perhaps I will set up this carve to run on the Maslow just to see how it works out. I have done some fine detailed carves with the M2, so it can definitely do it.

Have a look at [My Maslow Adventures](https://forums.maslowcnc.com/t/my-maslow-adventures/18910/) to see some of the things I have done with the M2.

---

_[View the full topic](https://forums.maslowcnc.com/t/fail-of-the-week/20742)._