# Find Anchor Locations endlessly slowly extends belts **URL:** \ **Category:** Troubleshooting\ **Created:** [January 12, 2026, 7:39am UTC](https://forums.maslowcnc.com/t/find-anchor-locations-endlessly-slowly-extends-belts/25418 "2026-01-12T07:39:59Z")\ **Posts on this page:** 1\ **Showing post:** 4
**Author:** ![bar](https://yyz1.discourse-cdn.com/flex031/user_avatar/forums.maslowcnc.com/bar/32/10_2.png) [@bar](https://forums.maslowcnc.com/u/bar)\ **Post date:** [January 12, 2026, 5:55pm UTC](https://forums.maslowcnc.com/t/find-anchor-locations-endlessly-slowly-extends-belts/25418/4 "2026-01-12T17:55:44Z")
I vaguely do remember having seen this before (although not in a long long time). Ah I even found the thread: > [@Calibration process just unspools belts slowly](https://forums.maslowcnc.com/t/calibration-process-just-unspools-belts-slowly/23714): > > hey again here with problems… I uploaded 1.02 trough usb-c like the video tells to do, now belts a extended correctly! starting the calibration process, the maslow sometimes retracts the bottom belts very tight and the top belts not, getting " [MSG:INFO: Requesting state change from 4 to 6]". meanwhile the maslow just stops doing anything unless unspooling slowly all belts, the first time a tought this is normal and i just go a BIG mess with the belts pushed trough the arms in the worng way!!… A lot of the things that we suggested there (like changing the grid size) are fully automated at this point so you don’t even need to mess with those settings anymore. Can you post a copy of the log file? What happens if you pull out on the belts to let them extend? --- _[View the full topic](https://forums.maslowcnc.com/t/find-anchor-locations-endlessly-slowly-extends-belts/25418)._