# Fusion 360 pocket cuts are short **URL:** \ **Category:** No Judgement\ **Created:** [December 14, 2020, 1:24am UTC](https://forums.maslowcnc.com/t/fusion-360-pocket-cuts-are-short/15503 "2020-12-14T01:24:05Z")\ **Posts on this page:** 3\ **Page:** 1
**Author:** ![Tisha\_Franks](https://yyz1.discourse-cdn.com/flex031/user_avatar/forums.maslowcnc.com/tisha_franks/32/13292_2.png) [@Tisha\_Franks](https://forums.maslowcnc.com/u/Tisha_Franks)\ **Post date:** [December 14, 2020, 1:24am UTC](https://forums.maslowcnc.com/t/fusion-360-pocket-cuts-are-short/15503/1 "2020-12-14T01:24:05Z")
My 2d contour cuts are spot on. The 2d pocket are not coming out correctly. About 1/8 short. Tried adaptive option and the same thing happens… I’ve unchecked leave extra stock so I’m not sure what’s going on ---
**Author:** ![thekantorfour](https://yyz1.discourse-cdn.com/flex031/user_avatar/forums.maslowcnc.com/thekantorfour/32/18687_2.png) [@thekantorfour](https://forums.maslowcnc.com/u/thekantorfour)\ **Post date:** [December 15, 2020, 5:33pm UTC](https://forums.maslowcnc.com/t/fusion-360-pocket-cuts-are-short/15503/2 "2020-12-15T17:33:42Z")
I don’t have much experience with Fusion 360, so I can’t speak to the settings there. Have you checked the GCode to see if it’s showing the correct Z depth? If it’s showing the right depth, it might be a hardware issue. ---
**Author:** ![Tisha\_Franks](https://yyz1.discourse-cdn.com/flex031/user_avatar/forums.maslowcnc.com/tisha_franks/32/13292_2.png) [@Tisha\_Franks](https://forums.maslowcnc.com/u/Tisha_Franks)\ **Post date:** [December 15, 2020, 5:52pm UTC](https://forums.maslowcnc.com/t/fusion-360-pocket-cuts-are-short/15503/3 "2020-12-15T17:52:54Z")
It seemed to be a twofold issue… I noticed my verticals cuts where off but not horizontally. Read something about rotational radius needing to be close to 140mm. Mine was off below 130mm so did a quick recalibrate and all was good .