# GCode Glitch on the maslow

**URL:** <https://forums.maslowcnc.com/t/gcode-glitch-on-the-maslow/5919>\
**Category:** Troubleshooting\
**Tags:** groundcontrol\
**Created:** [August 17, 2018, 11:00pm UTC](https://forums.maslowcnc.com/t/gcode-glitch-on-the-maslow/5919 "2018-08-17T23:00:18Z")\
**Posts on this page:** 1\
**Showing post:** 16

<div class="post-metadata">

**Author:** ![Gero](https://yyz1.discourse-cdn.com/flex031/user_avatar/forums.maslowcnc.com/gero/32/17487_2.png) [@Gero](https://forums.maslowcnc.com/u/Gero)\
**Post date:** [August 19, 2018, 4:44am UTC](https://forums.maslowcnc.com/t/gcode-glitch-on-the-maslow/5919/16 "2018-08-19T04:44:50Z")

</div>

I have a spare arduino mega in the home office for this task. You don’t need a motor shield or anything else attached to it. A small edit in the firmware before you upload it to the mega and you can run GC. Be aware that the Arduino IDE stores that change without asking, so I don’t do this in the workshop. Just to make sure that I’m not wondering for hours why the Maslow is not working 🙂

> [@Questions about installing GroundControl on MacOS](https://forums.maslowcnc.com/t/questions-about-installing-groundcontrol-on-macos/2091/5):
>
> If you’ve got a spare Arduino Mega available, there’s a way to “play around” with GroundControl while you wait :grinning\_face\_with\_smiling\_eyes:for the kit… In the firmware look in the file ‘cnc\_cntrl\_v1/Config.h’ and uncomment the line // #define FAKE\_SERVO // Uncomment this line to cause the Firmware to mimic (it becomes:) #define FAKE\_SERVO // Uncomment this line to cause the Firmware to mimic Upload to the Arduino Mega and you can tell GroundControl which port it’s connected…

The top terminal is the command window GC is started from. The second is a ‘tail’ on the log file (Linux). I use vlc to record my desctop 12f/sec.

---

_[View the full topic](https://forums.maslowcnc.com/t/gcode-glitch-on-the-maslow/5919)._
