# GCode Previews\*

**URL:** <https://forums.maslowcnc.com/t/gcode-previews/1237>\
**Category:** Software\
**Created:** [November 27, 2017, 4:58am UTC](https://forums.maslowcnc.com/t/gcode-previews/1237 "2017-11-27T04:58:57Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![Bee](https://yyz1.discourse-cdn.com/flex031/user_avatar/forums.maslowcnc.com/bee/32/2160_2.png) [@Bee](https://forums.maslowcnc.com/u/Bee)\
**Post date:** [November 27, 2017, 4:58am UTC](https://forums.maslowcnc.com/t/gcode-previews/1237/1 "2017-11-27T04:58:57Z")

</div>

I found this while looking at stuff for the shapeoko3 but might be useful here too -

[https://www.shapeoko.com/wiki/index.php/Previewing\_G-Code](https://www.shapeoko.com/wiki/index.php/Previewing_G-Code)

Thank you

---

<div class="post-metadata">

**Author:** ![blurfl](https://yyz1.discourse-cdn.com/flex031/user_avatar/forums.maslowcnc.com/blurfl/32/9_2.png) [@blurfl](https://forums.maslowcnc.com/u/blurfl)\
**Post date:** [November 27, 2017, 5:12am UTC](https://forums.maslowcnc.com/t/gcode-previews/1237/2 "2017-11-27T05:12:32Z")

</div>

That would be _very_ useful in the wiki 😉 😄