# Ground Control message continually toggles from "Connected" to "Not Connected" **URL:** \ **Category:** Software\ **Created:** [November 19, 2017, 9:04am UTC](https://forums.maslowcnc.com/t/ground-control-message-continually-toggles-from-connected-to-not-connected/1129 "2017-11-19T09:04:00Z")\ **Posts on this page:** 1\ **Showing post:** 74
**Author:** ![Bee](https://yyz1.discourse-cdn.com/flex031/user_avatar/forums.maslowcnc.com/bee/32/2160_2.png) [@Bee](https://forums.maslowcnc.com/u/Bee)\ **Post date:** [January 27, 2019, 7:27pm UTC](https://forums.maslowcnc.com/t/ground-control-message-continually-toggles-from-connected-to-not-connected/1129/74 "2019-01-27T19:27:41Z")
please look over this thread - > [@Arduino Problem](https://forums.maslowcnc.com/t/arduino-problem/8623/5): > > SilasB, it may be other wires or interference. My suggestions; I would separate all the cables an inch or two including the motor/encoder cables if they are close (they are not twisted pair or shielded lines), Place chokes on all power and usb cable (or use a USB with a choke built in), My router was electronically the nosiest and got worse with a few hours of run time. So you may have been almost interfering when new, but over the limit with some router age. Don’t secure any cables close to … Thank you --- _[View the full topic](https://forums.maslowcnc.com/t/ground-control-message-continually-toggles-from-connected-to-not-connected/1129)._