# GroundControl has no cursor? **URL:** \ **Category:** Ground Control\ **Created:** [June 13, 2018, 1:34am UTC](https://forums.maslowcnc.com/t/groundcontrol-has-no-cursor/4348 "2018-06-13T01:34:31Z")\ **Posts on this page:** 1\ **Showing post:** 11
**Author:** ![Bee](https://yyz1.discourse-cdn.com/flex031/user_avatar/forums.maslowcnc.com/bee/32/2160_2.png) [@Bee](https://forums.maslowcnc.com/u/Bee)\ **Post date:** [June 13, 2018, 3:03am UTC](https://forums.maslowcnc.com/t/groundcontrol-has-no-cursor/4348/11 "2018-06-13T03:03:16Z")
No try this one. > [@Raspberry Pi Cursor](https://forums.maslowcnc.com/t/raspberry-pi-cursor/2019): > > Hi, I am new here so I apologise if this has already been covered (I couldn’t find the information on these forums so thought I would post it hoping it may help someone else). Whilst waiting for my Maslow kit to arrive I thought I would setup my Raspberry Pi 3 to run ground control. I am not a fan of using touch screens so ran into the documented problem with the mouse cursor not being displayed. I tried editing the config.ini to set “touchring = show\_cursor=true” but couldn’t get that to wo… there are also alternate instructions to a diffrent solution here too: > [@Raspberry Pi with KDE Window Manager, Wayland ver](https://forums.maslowcnc.com/t/raspberry-pi-with-kde-window-manager-wayland-ver/2213): > > Raspberry Pi running in KDE Window Manager, wayland version This is a solution, I came up with for running GroundControl or kivy python apps inside an X11 window manager while using a mouse or touchpad. If you are using a touchscreen then running KivyPie is probably the safe choice or running kivypie with the trapped cursor mod that was discussed and uploaded by Kingley in this earlier [forum thread](https://forums.maslowcnc.com/t/raspberry-pi-cursor/2019). [Disclaimer] As of this writing I have not yet received my Maslow kit, and I have only been able… Thank you --- _[View the full topic](https://forums.maslowcnc.com/t/groundcontrol-has-no-cursor/4348)._