# Has any one cut Oak?

**URL:** <https://forums.maslowcnc.com/t/has-any-one-cut-oak/5237>\
**Category:** No Judgement\
**Created:** [July 28, 2018, 4:28pm UTC](https://forums.maslowcnc.com/t/has-any-one-cut-oak/5237 "2018-07-28T16:28:16Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![Scornell](https://yyz1.discourse-cdn.com/flex031/user_avatar/forums.maslowcnc.com/scornell/32/7608_2.png) [@Scornell](https://forums.maslowcnc.com/u/Scornell)\
**Post date:** [July 28, 2018, 4:28pm UTC](https://forums.maslowcnc.com/t/has-any-one-cut-oak/5237/1 "2018-07-28T16:28:17Z")

</div>

I’m new here trying to figure out a few things can you only cut sheets of things? Or if I built a ledger board on the top and the bottom so that the router will have a flat surface can I put a piece of oak in between them and route out some oak?

---

<div class="post-metadata">

**Author:** ![jwolter](https://yyz1.discourse-cdn.com/flex031/user_avatar/forums.maslowcnc.com/jwolter/32/30787_2.png) [@jwolter](https://forums.maslowcnc.com/u/jwolter)\
**Post date:** [July 28, 2018, 5:17pm UTC](https://forums.maslowcnc.com/t/has-any-one-cut-oak/5237/2 "2018-07-28T17:17:06Z")

</div>

This topic got caught in the spam filters. I approved it, but not before @Scornell re-posted it in projects. So I’m going to lock this one and refer everyone to the other one. [Has anyone cut oak?](https://forums.maslowcnc.com/t/has-anyone-cut-oak/5241)

---

<div class="post-metadata">

**Author:** ![jwolter](https://yyz1.discourse-cdn.com/flex031/user_avatar/forums.maslowcnc.com/jwolter/32/30787_2.png) [@jwolter](https://forums.maslowcnc.com/u/jwolter)\
**Post date:** [July 28, 2018, 5:17pm UTC](https://forums.maslowcnc.com/t/has-any-one-cut-oak/5237/3 "2018-07-28T17:17:17Z")

</div>

Closed on July 28, 2018, 5:17pm UTC


