# Holey and Makerverse on mega original Maslow not functioning **URL:** \ **Category:** Troubleshooting\ **Created:** [January 24, 2021, 8:06pm UTC](https://forums.maslowcnc.com/t/holey-and-makerverse-on-mega-original-maslow-not-functioning/15914 "2021-01-24T20:06:18Z")\ **Posts on this page:** 1\ **Showing post:** 12
**Author:** ![Sprasher](https://yyz1.discourse-cdn.com/flex031/user_avatar/forums.maslowcnc.com/sprasher/32/7695_2.png) [@Sprasher](https://forums.maslowcnc.com/u/Sprasher)\ **Post date:** [January 25, 2021, 10:26pm UTC](https://forums.maslowcnc.com/t/holey-and-makerverse-on-mega-original-maslow-not-functioning/15914/12 "2021-01-25T22:26:51Z")
of days on and off trying to get things to work. Thanks again and I’ll post what happens. [![](https://yyz1.discourse-cdn.com/flex031/user_avatar/forums.maslowcnc.com/sprasher/45/7695_2.png)](https://forums.maslowcnc.com/u/Sprasher) [Sprasher](https://forums.maslowcnc.com/u/Sprasher) [3m](https://forums.maslowcnc.com/t/holey-and-makerverse-on-mega-original-maslow-not-functioning/15914/12) I followed the instructions and tried several times deleted and replaced arduino, Makerverse and firmware to make sure I was using the correct versions. Not working still arduino compiles sketch uploads and says done with the the following message. Sketch uses 62284 bytes (24%) of program storage space. Maximum is 253952 bytes. Global variables use 2047 bytes (24%) of dynamic memory, leaving 6145 bytes for local variables. Maximum is 8192 bytes. Makerverse still has pink box - Firmware: Required version: v51.28 Confirmed Protocol: **Maslow** At Baud Rate: **57600** Response Protocol: **Grbl v1.00** Firmware: **MaslowClassic v1.28** I don’t know if any of this helps explain what is happening! I am using my tower with win 10 and will bring my laptop over to the shop after lunch and see if that changes anything. Any advice help? --- _[View the full topic](https://forums.maslowcnc.com/t/holey-and-makerverse-on-mega-original-maslow-not-functioning/15914)._