# Is it me, or is it Z?

**URL:** <https://forums.maslowcnc.com/t/is-it-me-or-is-it-z/3683>\
**Category:** Troubleshooting\
**Created:** [May 1, 2018, 3:09pm UTC](https://forums.maslowcnc.com/t/is-it-me-or-is-it-z/3683 "2018-05-01T15:09:08Z")\
**Posts on this page:** 1\
**Showing post:** 5

<div class="post-metadata">

**Author:** ![Tyler\_W\_Cox](https://avatars.discourse-cdn.com/v4/letter/t/ebca7d/32.png) [@Tyler\_W\_Cox](https://forums.maslowcnc.com/u/Tyler_W_Cox)\
**Post date:** [May 1, 2018, 3:52pm UTC](https://forums.maslowcnc.com/t/is-it-me-or-is-it-z/3683/5 "2018-05-01T15:52:56Z")

</div>

Used the same process / origin for Fusion 360 that I did for my first cut over here:

> [@Cutting speed doesn't seem right](https://forums.maslowcnc.com/t/cutting-speed-doesnt-seem-right/3557/10):
>
> Thanks for all your help. I simplified the paths in the SVG, tweaked the image a little, and minified the file reducing the decimal precision. [alice2] I then dropped the tolerance in Fusion 360 to 0.1 inches which produced much less dense g-code. [alice2.nc](https://forums.maslowcnc.com/uploads/maslowcnc/original/2X/8/8c0b9d1dc416d3cf6999b31cbc2e3858e0e818e0.nc) (725.6 KB) The final result cut in about 3 hours.

Only this time I used a more reasonable 0.015 inch tolerance rather than the .0004 mm tolerance that slowed down my first project.

I was hoping more G Code knowledge from 3d printing would transfer over to CAM. Unfortunately, it looks like I still have some learning ahead of me.

---

_[View the full topic](https://forums.maslowcnc.com/t/is-it-me-or-is-it-z/3683)._