# Is there a Factory reset?

**URL:** <https://forums.maslowcnc.com/t/is-there-a-factory-reset/24699>\
**Category:** Troubleshooting\
**Created:** [August 11, 2025, 10:16pm UTC](https://forums.maslowcnc.com/t/is-there-a-factory-reset/24699 "2025-08-11T22:16:11Z")\
**Posts on this page:** 1\
**Showing post:** 2

<div class="post-metadata">

**Author:** ![Tore](https://yyz1.discourse-cdn.com/flex031/user_avatar/forums.maslowcnc.com/tore/32/25202_2.png) [@Tore](https://forums.maslowcnc.com/u/Tore)\
**Post date:** [August 11, 2025, 10:49pm UTC](https://forums.maslowcnc.com/t/is-there-a-factory-reset/24699/2 "2025-08-11T22:49:59Z")

</div>

Yes. If you can connect to the Maslow via WiFi and get to the WebGUI, you can delete and upload files from there. The Maslow.yaml and index.html.gz can not be called anything else. Depending on the firmware you have installed, you can rename files or delete them before uploading new files.

> **[User Guide — Maslow](https://www.maslowcnc.com/user-guide)**

You can also set it in boot-mode to re-install firmware via USB.

> [@Trying to Install FluidNC v1.0](https://forums.maslowcnc.com/t/trying-to-install-fluidnc-v1-0/23578/22):
>
> There is a black button on the control board (you will probably need to take of the cover with the fan to see it). Holding down that button will put the board in “boot mode” which will make it easier to program. To get it to work the order has to be hold down the button and THEN plug in the power (while keeping the button held down)

More info on that here: [Trying to Install FluidNC v1.0 - #22 by bar](https://forums.maslowcnc.com/t/trying-to-install-fluidnc-v1-0/23578/22)

---

_[View the full topic](https://forums.maslowcnc.com/t/is-there-a-factory-reset/24699)._