# looking for an alternative to the DEWALT DWP611

**URL:** <https://forums.maslowcnc.com/t/looking-for-an-alternative-to-the-dewalt-dwp611/24831>\
**Category:** Hardware\
**Created:** [September 8, 2025, 4:42pm UTC](https://forums.maslowcnc.com/t/looking-for-an-alternative-to-the-dewalt-dwp611/24831 "2025-09-08T16:42:52Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![mala](https://avatars.discourse-cdn.com/v4/letter/m/258eb7/32.png) [@mala](https://forums.maslowcnc.com/u/mala)\
**Post date:** [September 8, 2025, 4:42pm UTC](https://forums.maslowcnc.com/t/looking-for-an-alternative-to-the-dewalt-dwp611/24831/1 "2025-09-08T16:42:52Z")

</div>

```auto
I am looking for an alternative to the DEWALT DWP611 router because it is impossible to order it in France.

```

```auto

```

---

<div class="post-metadata">

**Author:** ![dlang](https://yyz1.discourse-cdn.com/flex031/user_avatar/forums.maslowcnc.com/dlang/32/859_2.png) [@dlang](https://forums.maslowcnc.com/u/dlang)\
**Post date:** [September 8, 2025, 6:33pm UTC](https://forums.maslowcnc.com/t/looking-for-an-alternative-to-the-dewalt-dwp611/24831/2 "2025-09-08T18:33:59Z")

</div>

Malabarr4321 wrote:

> I am looking for an alternative to the DEWALT DWP611 router because it is impossible to order it in France.

look at the router-b-gone threads

David Lang

---

<div class="post-metadata">

**Author:** ![bar](https://yyz1.discourse-cdn.com/flex031/user_avatar/forums.maslowcnc.com/bar/32/10_2.png) [@bar](https://forums.maslowcnc.com/u/bar)\
**Post date:** [September 8, 2025, 6:38pm UTC](https://forums.maslowcnc.com/t/looking-for-an-alternative-to-the-dewalt-dwp611/24831/3 "2025-09-08T18:38:37Z")

</div>

Here is a link to that thread if it’s hard to find:

> [@M4 Router Be Gone (installed the spindle)](https://forums.maslowcnc.com/t/m4-router-be-gone-installed-the-spindle/21389):
>
> So this is the follow up to: And I’m thinking may have relevance to [Maslow plotter, or getting used to Maslow without spoiling wood](https://forums.maslowcnc.com/t/maslow-plotter-or-getting-used-to-maslow-without-spoiling-wood/21237) So I got the spindle’s PSU mounted into a power box, with emergency reset, switch for the M4, switch for the spindle, and the spindle’s speed control. The housing for the spindle is in two parts. There’s an outer sleeve (which was too thick by 0.4mm so I had to reprint it), and an inner sleeve made to give the spindle support, but allow l…