# M0/M1 Support in Ground Control? **URL:** \ **Category:** Software\ **Created:** [October 4, 2017, 6:58pm UTC](https://forums.maslowcnc.com/t/m0-m1-support-in-ground-control/777 "2017-10-04T18:58:14Z")\ **Posts on this page:** 1\ **Showing post:** 5
**Author:** ![MeticulousMaynard](https://yyz1.discourse-cdn.com/flex031/user_avatar/forums.maslowcnc.com/meticulousmaynard/32/2744_2.png) [@MeticulousMaynard](https://forums.maslowcnc.com/u/MeticulousMaynard)\ **Post date:** [October 4, 2017, 9:20pm UTC](https://forums.maslowcnc.com/t/m0-m1-support-in-ground-control/777/5 "2017-10-04T21:20:38Z")
No rush on it, I know you’ve got a lot going on right now. I’m sure there are uses for program stops that i’m not thinking of right now, but for what I can think of right now you have already added another method for dealing with it, or simply its not needed. For instance, the Z-height changes, or removing/adjusting parts after they have been cut. I’m sure that, at some point, I’ll find a need for it and then I really will need it but nothing is coming to mind right now. Most of the M codes don’t really apply to the Maslow, anyways. The only ones that I think could come in handy would be M0, M1, M2, M3, M5, and M30. M3 and M5 would go along the lines of [another thread](http://forums.maslowcnc.com/t/auto-power-switch-for-router/406) about allowing G-code to turn on the spindle. I learned to machine on a Haas Mini-mill where you had to spell everything out, and my style of programming will probably reflect that a little bit. EDIT: Found the other thread, linked it for reference --- _[View the full topic](https://forums.maslowcnc.com/t/m0-m1-support-in-ground-control/777)._