# Maslow h no such file
**URL:** https://forums.maslowcnc.com/t/maslow-h-no-such-file/11795
**Category:** Troubleshooting
**Created:** [December 5, 2019, 8:21pm UTC](https://forums.maslowcnc.com/t/maslow-h-no-such-file/11795 "2019-12-05T20:21:31Z")
**Posts on this page:** 4
**Page:** 1
### Author:  [@suprastbh](https://forums.maslowcnc.com/u/suprastbh)
#### Post date: [December 5, 2019, 8:21pm UTC](https://forums.maslowcnc.com/t/maslow-h-no-such-file/11795/1 "2019-12-05T20:21:31Z")
Attempting to update firmware and ground control to 1.26 to accommodate TLE 5206. Updated Arduino to 1.8.10 Downloaded and unzipped firmware 1.26 .input board type and port (same as before)but.when I try to upload I get… Maslow h no such file or directory. Deleted arduino and firmware files and tried again…any ideas. I do not have TLE 5206 installed yet.
---
### Author:  [@bar](https://forums.maslowcnc.com/u/bar)
#### Post date: [December 5, 2019, 9:04pm UTC](https://forums.maslowcnc.com/t/maslow-h-no-such-file/11795/2 "2019-12-05T21:04:18Z")
Usually that error message pops up if you try to upload the zipped version. Is there any chance the file open in the IDE is the one which hasn’t been unzipped yet?
---
### Author:  [@suprastbh](https://forums.maslowcnc.com/u/suprastbh)
#### Post date: [December 5, 2019, 9:38pm UTC](https://forums.maslowcnc.com/t/maslow-h-no-such-file/11795/3 "2019-12-05T21:38:04Z")
Arduino or firmware?
---
### Author:  [@suprastbh](https://forums.maslowcnc.com/u/suprastbh)
#### Post date: [December 6, 2019, 7:19pm UTC](https://forums.maslowcnc.com/t/maslow-h-no-such-file/11795/4 "2019-12-06T19:19:12Z")
10 th time is the charm recalibrating now