# Maslow Mark II - 3D **URL:** \ **Category:** Hardware\ **Created:** [March 12, 2019, 12:21am UTC](https://forums.maslowcnc.com/t/maslow-mark-ii-3d/9098 "2019-03-12T00:21:55Z")\ **Posts on this page:** 1\ **Showing post:** 74
**Author:** ![dlang](https://yyz1.discourse-cdn.com/flex031/user_avatar/forums.maslowcnc.com/dlang/32/859_2.png) [@dlang](https://forums.maslowcnc.com/u/dlang)\ **Post date:** [May 16, 2019, 6:02am UTC](https://forums.maslowcnc.com/t/maslow-mark-ii-3d/9098/74 "2019-05-16T06:02:39Z")
In case you missed it, that inspired me to make a 3d printable version, see > [@In search of accurate measurements](https://forums.maslowcnc.com/t/in-search-of-accurate-measurements/9581): > > at one point, someone posted a picture of a caliper setup that they had which used a tape measure that let you measure down to 1/10 mm over whatever length tape measure you have. I have created an item in onshape with the idea of 3D printing two of them, one to go on the end of a tape measure (any tape measure up to ~1" wide), and the other to be used for the measurement. These have pins to work with the holey triangulation calibration holes. However, my experien… David Lang --- _[View the full topic](https://forums.maslowcnc.com/t/maslow-mark-ii-3d/9098)._