# My Maslow is destroyed, please help me figure out what happened

**URL:** <https://forums.maslowcnc.com/t/my-maslow-is-destroyed-please-help-me-figure-out-what-happened/10748>\
**Category:** Troubleshooting\
**Created:** [August 4, 2019, 9:50pm UTC](https://forums.maslowcnc.com/t/my-maslow-is-destroyed-please-help-me-figure-out-what-happened/10748 "2019-08-04T21:50:27Z")\
**Posts on this page:** 1\
**Showing post:** 8

<div class="post-metadata">

**Author:** ![WoodCutter4](https://avatars.discourse-cdn.com/v4/letter/w/bc79bd/32.png) [@WoodCutter4](https://forums.maslowcnc.com/u/WoodCutter4)\
**Post date:** [August 5, 2019, 12:25pm UTC](https://forums.maslowcnc.com/t/my-maslow-is-destroyed-please-help-me-figure-out-what-happened/10748/8 "2019-08-05T12:25:17Z")

</div>

EDIT2: nevermind. I can see from your log you are using v1.26.

@Blazman what GC and FW versions are you using?

I’m now having an issue with the black and red crosshairs not following each other and the machine is not stopping; no errors. For me, the black crosshairs follow the bit but the red crosshairs “get stuck”. I have unplugged and plugged in my cables. I have not had any issues with a run-away sled, and I’m using custom firmware based on v1.26, but just thought I’d ask. I have not had this issue with the custom firmware I’m using when it was in sync with v1.25 GC/FW.

---

_[View the full topic](https://forums.maslowcnc.com/t/my-maslow-is-destroyed-please-help-me-figure-out-what-happened/10748)._
