# Parametric table

**URL:** <https://forums.maslowcnc.com/t/parametric-table/25599>\
**Category:** Abundance\
**Created:** [March 9, 2026, 3:36am UTC](https://forums.maslowcnc.com/t/parametric-table/25599 "2026-03-09T03:36:11Z")\
**Posts on this page:** 1\
**Page:** 1

<div class="post-metadata">

**Author:** ![wouldchuck](https://avatars.discourse-cdn.com/v4/letter/w/58956e/32.png) [@wouldchuck](https://forums.maslowcnc.com/u/wouldchuck)\
**Post date:** [March 9, 2026, 3:36am UTC](https://forums.maslowcnc.com/t/parametric-table/25599/1 "2026-03-09T03:36:12Z")

</div>

Fun with abundance. It is snowy here so there is no actual maslow cutting. I needed a table to make a model for Project Floor Spider (maslow with router upside down under a table with the workpiece and wasteboard taped to the underside of the table so that the maslow can cut deep relief without riding on it). I didn’t have a table model so I designed one.

I have planned it for 3/4 inch plywood but it can be adjusted.

It would need

- 32 screws for the legs attaching to the corners. Four for the inside in pre made pockets. Four for the outside corners
- Glue to laminate the two piecs of each leg.
- 4 bolts, washers and nuts to attach the legs
- Lots of little screws and perhaps 4 1x1 pieces of wood to screw the top of the table on.

It would probably be good to have a compound miter saw to trim the corners of the edges and braces on the diagonal.

You can adjust almost everything about the table by playing with the parameters.

I have learned that you can use inputs as named variables to write equations inside the other atoms. To pass a variable into a molecule you still need to connect a connecting wire into it’s inputs. Then use the name of the molecule’s inputs as the new variable inside that molecule.

 ![image](https://canada1.discourse-cdn.com/flex031/uploads/maslowcnc/original/3X/d/9/d954152cb7ec6a570301d65441147a387d117b5e.jpeg)

[https://abundance.maslowcnc.com/run/wouldchuckit/Table\_With\_Tapered\_Legs\_and\_Rounded\_Corners](https://abundance.maslowcnc.com/run/wouldchuckit/Table_With_Tapered_Legs_and_Rounded_Corners)

Fun cause it’s parametric.

 ![Screenshot from 2026-03-08 21-53-06](https://canada1.discourse-cdn.com/flex031/uploads/maslowcnc/original/3X/2/9/29ec47ae3b815a51c4cc4a63e628bb673bb54c03.jpeg)

 ![Screenshot from 2026-03-08 21-46-31](https://canada1.discourse-cdn.com/flex031/uploads/maslowcnc/original/3X/6/c/6c8e5e2dd6a58285335193d4660b6676690be6dd.jpeg)