# Possible super-simple frame

**URL:** https://forums.maslowcnc.com/t/possible-super-simple-frame/20306
**Category:** Technical Details
**Created:** [March 22, 2024, 5:04am UTC](https://forums.maslowcnc.com/t/possible-super-simple-frame/20306 "2024-03-22T05:04:26Z")
**Posts on this page:** 1
**Showing post:** 62

<div class="post-metadata">

### Author: ![Andith](https://avatars.discourse-cdn.com/v4/letter/a/6f9a4e/32.png) [@Andith](https://forums.maslowcnc.com/u/Andith)
#### Post date: [November 22, 2024, 7:36pm UTC](https://forums.maslowcnc.com/t/possible-super-simple-frame/20306/62 "2024-11-22T19:36:03Z")

</div>

> [@redman\_no1](#):
>
> ’m less worried about the drilling part, and just the prospect of having holes In the garage that I have to keep clean, and bolts in have to work around

I have 3/8" anchors and a piece of 3/8" threaded rod going down to the anchors. When not using my M4, the anchors are pretty unobtrusive or I can quickly unscrew the threaded rod and pop in a 3/8" hex bolt instead to keep the hole clean and then the only thing protruding up is the head of the hex bolt.

If needed later on, I can always get a bit of quick mix cement and fill the holes back in (drop in anchors and all) and it’ll be like nothing was ever there.

> [@redman\_no1](#):
>
> Thanks, I was aware of those. but I’ve seen some other suggections for 3d printing anchors that account for the offset to each of the 4 belts to keep the belts level. Is there a consensus on if those style anchors are better?

I wouldn’t worry about that offset for now. The difference the offset makes is likely pretty minimal and likely only an issue when making cuts closer to an anchor. Getting a frame set up and making cuts is much more important. You can always go back, make changes, and fine tune things later if you’d like.

---

_[View the full topic](https://forums.maslowcnc.com/t/possible-super-simple-frame/20306)._