# Stops cutting mid cut total newbie

**URL:** <https://forums.maslowcnc.com/t/stops-cutting-mid-cut-total-newbie/8569>\
**Category:** Troubleshooting\
**Created:** [January 22, 2019, 1:37am UTC](https://forums.maslowcnc.com/t/stops-cutting-mid-cut-total-newbie/8569 "2019-01-22T01:37:22Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![Ryan\_Ahlstrom](https://avatars.discourse-cdn.com/v4/letter/r/ecb155/32.png) [@Ryan\_Ahlstrom](https://forums.maslowcnc.com/u/Ryan_Ahlstrom)\
**Post date:** [January 22, 2019, 1:37am UTC](https://forums.maslowcnc.com/t/stops-cutting-mid-cut-total-newbie/8569/1 "2019-01-22T01:37:22Z")

</div>

Hello  
I finally got my Maslow up and running and the first cuts I am trying to do just stop mid cut in different locations. If I press the stop button and restart it goes back to the beginning and begins cut again only to stop in a different location. I am trying to cut the logo as a first cut any ideas I have the latest ground control edition and the latest firmware any help would be Greatly appreciated  
Thank you Uploading: 85670B3E-002A-442E-B593-14D9540751C7.jpeg… Uploading: 02ED1B2E-B499-4896-83D7-511CADB39960.jpeg…

---

<div class="post-metadata">

**Author:** ![Gero](https://yyz1.discourse-cdn.com/flex031/user_avatar/forums.maslowcnc.com/gero/32/17487_2.png) [@Gero](https://forums.maslowcnc.com/u/Gero)\
**Post date:** [January 22, 2019, 8:10am UTC](https://forums.maslowcnc.com/t/stops-cutting-mid-cut-total-newbie/8569/2 "2019-01-22T08:10:33Z")

</div>

Greetings from a Human 🖖 (not a bot)  
Welcome to the Forum!  
To pause the cut, use the yellow ‘pause button’ in the middle. Clicking it again will ‘un-pause’ the cut and continue from where you paused.  
Stop and start will do exactly as you described.

Hope that helps, regards, Gero