# Test request (weight and angle)

**URL:** <https://forums.maslowcnc.com/t/test-request-weight-and-angle/2494>\
**Category:** Ground Control\
**Created:** [February 24, 2018, 8:12pm UTC](https://forums.maslowcnc.com/t/test-request-weight-and-angle/2494 "2018-02-24T20:12:58Z")\
**Posts on this page:** 1\
**Showing post:** 2

<div class="post-metadata">

**Author:** ![MeticulousMaynard](https://yyz1.discourse-cdn.com/flex031/user_avatar/forums.maslowcnc.com/meticulousmaynard/32/2744_2.png) [@MeticulousMaynard](https://forums.maslowcnc.com/u/MeticulousMaynard)\
**Post date:** [February 26, 2018, 7:42pm UTC](https://forums.maslowcnc.com/t/test-request-weight-and-angle/2494/2 "2018-02-26T19:42:44Z")

</div>

David, sorry this got ignored. Had a busy weekend away from the Maslow. I’m hoping to get back to my machine this next weekend.

> [@dlang](#):
>
> I remember there is one person (I don’t remember who) who has stacks of steel blocks as their weights, could you go back to lighter weights and run the calibration/test steps multiple times with different weights to see what happens?

Are you referring to these?

 ![IMG_20171109_194316](https://canada1.discourse-cdn.com/flex031/uploads/maslowcnc/original/2X/1/1d3c8f89b4c0b2620b96290cefd62f75223f1f4b.jpg)

I’ve been meaning to experiment with different weights now that we have chain sag calculations. Each one of the steel weights are ~550g, or ~20 oz. I can systematically reduce the weight, run the calibration routine, and then benchmark the resulting configuration so we have comparable results. If I remove 4 weights at a time, I can test in 5 lb increments. I think that should give us sufficient data.

> [@dlang](#):
>
> Also, if someone could test different tilt angles of the machine, the default is about 15 degrees and earlier testing showed that going below 5 degrees caused problems.

While I have been thinking of a mechanism to allow it, I currently don’t have any adjustment in my machine’s angle. I would like to be able to test that too, but I have so many other machine improvements and projects I need to get to it would take me quite some time to get to a place where I can test that.

---

_[View the full topic](https://forums.maslowcnc.com/t/test-request-weight-and-angle/2494)._
