# Web Control: Raspberry Pi 3 B+ Starter kit?

**URL:** <https://forums.maslowcnc.com/t/web-control-raspberry-pi-3-b-starter-kit/11962>\
**Category:** No Judgement\
**Created:** [December 26, 2019, 2:42pm UTC](https://forums.maslowcnc.com/t/web-control-raspberry-pi-3-b-starter-kit/11962 "2019-12-26T14:42:09Z")\
**Posts on this page:** 1\
**Showing post:** 5

<div class="post-metadata">

**Author:** ![Printer\_V](https://yyz1.discourse-cdn.com/flex031/user_avatar/forums.maslowcnc.com/printer_v/32/13135_2.png) [@Printer\_V](https://forums.maslowcnc.com/u/Printer_V)\
**Post date:** [December 26, 2019, 6:08pm UTC](https://forums.maslowcnc.com/t/web-control-raspberry-pi-3-b-starter-kit/11962/5 "2019-12-26T18:08:50Z")

</div>

I am running almost that EXACT same setup on mine. I used the file posted here:  
[Webcontrol image](https://forums.maslowcnc.com/t/webcontrol-raspberrypi-install-from-image-file/11884)

I used a TV screen (via HDMI) to do my initial setup from the command line. Once it was up and running, I have not plugged it into the monitor again.

I am extremely happy with it so far. I was planning on adding a touch screen to the Pi but after using the webcontrol for a little while now, I don’t think I will need that at all (everything can be done through a browser on your phone).

I am still trying to figure out if there is anything that can be done about the camera choking the system when viewing but otherwise it is FANTASTIC!

---

_[View the full topic](https://forums.maslowcnc.com/t/web-control-raspberry-pi-3-b-starter-kit/11962)._