# Wifi conection instead of usb

**URL:** <https://forums.maslowcnc.com/t/wifi-conection-instead-of-usb/18862>\
**Category:** Uncategorized\
**Created:** [May 12, 2023, 12:25am UTC](https://forums.maslowcnc.com/t/wifi-conection-instead-of-usb/18862 "2023-05-12T00:25:50Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![Brat](https://yyz1.discourse-cdn.com/flex031/user_avatar/forums.maslowcnc.com/brat/32/19628_2.png) [@Brat](https://forums.maslowcnc.com/u/Brat)\
**Post date:** [May 12, 2023, 12:25am UTC](https://forums.maslowcnc.com/t/wifi-conection-instead-of-usb/18862/1 "2023-05-12T00:25:50Z")

</div>

Is it possable to connect to connect with a wifi connection instead of a usb for the maslow?

---

<div class="post-metadata">

**Author:** ![c00nphrog](https://yyz1.discourse-cdn.com/flex031/user_avatar/forums.maslowcnc.com/c00nphrog/32/13632_2.png) [@c00nphrog](https://forums.maslowcnc.com/u/c00nphrog)\
**Post date:** [May 12, 2023, 1:08am UTC](https://forums.maslowcnc.com/t/wifi-conection-instead-of-usb/18862/2 "2023-05-12T01:08:01Z")

</div>

Depending on your board, it is possible, but I’m not sure if it has been done or how it would be.

A work around that most use for WebControl connects the control board (via a short USB) a Raspberry Pi WebControl installed (search the forums here for RPi and you should find the instructions on how to do that). Then you can use a Web Browser with the IP Address of the Pi and Port 5000 (x.x.x.x:5000) and it will connect to the Pi over WiFi and can do all that is needed to cut. I do it this way using a Surface tablet and it works great. I know others that use their phone and at least one that uses a Fire tablet.