# Would it be possible to churn out something this precise?

**URL:** <https://forums.maslowcnc.com/t/would-it-be-possible-to-churn-out-something-this-precise/226>\
**Category:** No Judgement\
**Created:** [July 23, 2017, 8:01pm UTC](https://forums.maslowcnc.com/t/would-it-be-possible-to-churn-out-something-this-precise/226 "2017-07-23T20:01:48Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![raketemensch](https://avatars.discourse-cdn.com/v4/letter/r/8e7dd6/32.png) [@raketemensch](https://forums.maslowcnc.com/u/raketemensch)\
**Post date:** [July 23, 2017, 8:01pm UTC](https://forums.maslowcnc.com/t/would-it-be-possible-to-churn-out-something-this-precise/226/1 "2017-07-23T20:01:48Z")

</div>

I’m trying to find the right device to churn these suckers out, without the hole in the middle, which was created by a holesaw. The outer diameter is 66mm.

![](https://canada1.discourse-cdn.com/flex031/uploads/maslowcnc/original/1X/32dcb1bc7600c63e748604645a0dd657e5a58fbc.jpg)

---

<div class="post-metadata">

**Author:** ![blurfl](https://yyz1.discourse-cdn.com/flex031/user_avatar/forums.maslowcnc.com/blurfl/32/9_2.png) [@blurfl](https://forums.maslowcnc.com/u/blurfl)\
**Post date:** [July 23, 2017, 8:57pm UTC](https://forums.maslowcnc.com/t/would-it-be-possible-to-churn-out-something-this-precise/226/2 "2017-07-23T20:57:23Z")

</div>

That looks very doable, once you’re dialed in.

---

<div class="post-metadata">

**Author:** ![aluminumwelder](https://yyz1.discourse-cdn.com/flex031/user_avatar/forums.maslowcnc.com/aluminumwelder/32/9362_2.png) [@aluminumwelder](https://forums.maslowcnc.com/u/aluminumwelder)\
**Post date:** [July 23, 2017, 9:28pm UTC](https://forums.maslowcnc.com/t/would-it-be-possible-to-churn-out-something-this-precise/226/3 "2017-07-23T21:28:25Z")

</div>

drill press with clamp would work too and avoid the center hole.