# Z Depth + Ridgid Problems \[RESOLVED\]

**URL:** <https://forums.maslowcnc.com/t/z-depth-ridgid-problems-resolved/4030>\
**Category:** No Judgement\
**Created:** [May 22, 2018, 6:21pm UTC](https://forums.maslowcnc.com/t/z-depth-ridgid-problems-resolved/4030 "2018-05-22T18:21:27Z")\
**Posts on this page:** 1\
**Showing post:** 10

<div class="post-metadata">

**Author:** ![eightlines](https://yyz1.discourse-cdn.com/flex031/user_avatar/forums.maslowcnc.com/eightlines/32/5862_2.png) [@eightlines](https://forums.maslowcnc.com/u/eightlines)\
**Post date:** [May 25, 2018, 1:31pm UTC](https://forums.maslowcnc.com/t/z-depth-ridgid-problems-resolved/4030/10 "2018-05-25T13:31:33Z")

</div>

Thanks so much for the awesome suggestions!

@arnoldcp (1) I didn’t use any bungee cords on this test, I have the attached to the router, but I figured it was plunging fine on its own. (2) I’ve attached a photo of the anti-rotation groove, and I’m pretty sure you are correct, you can see where the tab is rubbing about halfway down and there’s a disjoint between the top and the bottom. I’ve started filing and I’ll test again once I’ve got things assembled this weekend. (3) Yes to the deflection.

@geeklimit I’ve tightened the housing grip, and I’ll test to see that the motor continues to move smoothly after I file down the anti-rotation channel.

 ![UNADJUSTEDNONRAW_thumb_1aec](https://canada1.discourse-cdn.com/flex031/uploads/maslowcnc/original/2X/7/705b4d74e4ef8d6882c56bafc47ed5d6c13c73bb.jpg)

Again, thanks for the suggestions! I’ll report back over the weekend.

---

_[View the full topic](https://forums.maslowcnc.com/t/z-depth-ridgid-problems-resolved/4030)._