A camera that fits in the hole in the middle of the Maslow to find center of workpiece?

[wouldchuck]

I finally had time to cut it out

Fun to do. I don’t think it is a particularly good tool as you still need to shine a bright light down the hole next to your eye.

What did you cut today?

Cutting a crosshairs mirror mount to sit in the maslow hole to center on a mark. Trying to cut from an abundance design. Very small pieces. 10mm thick particle board from a cabinet. One pass, maybe a bit too fast. The abundance gcode is ok, not good on the top corners that were meant to make straight cut shelves. Drilling operations are slow but seemed to work. Here is the thing I was trying to ideally cut and here is what happened. I might try it with slower travel speeds. and multiple pa…