Corner Floor Mounts and Pins

[Aggiehouse]

Here are the value names:
Maslow_tlZ
Maslow_trZ
Maslow_blZ
Maslow_brZ
Much more discussion here:

Observation and question about anchor points heights

I think that the default Z-values in the config (40, 60, 80, 100) are valid if you are using just a bolt to fasten the belt ends. Then there is no space between the spoil board and the belt ends. When using the 3d-printed anchors, there is some extra space between the spoil board and the belt ends. The belts are then a little (about 9 mm ?) closer to the arms so you could adjust the Z-values for this difference. I have raised 3 of my anchors so they are now all at different heights: [IMG_335…

Also, @bar can chime in for sure, but I could have sworn somebody said that to date these values haven’t been taken into account at all, but is something that will be incorporated in the future. Don’t know who said it, or if I imagined it, but it sure seems like i read that somewhere.