I have been experimenting producing gcode from *.stl files (3D). They tend to be very large depending on the cutting settings (depth of the layers, etc.). After seeing other posts, I installed GCodeClean (a utility that makes files smaller) recommended by Tore https://forums.maslowcnc.com/t/and-the-travelling-salesman-arrives-at-gcodeclean-v1-3-0/19688/74. It reduced the size of of 5.4 mb file to around 350 kb under the “hard” clean setting. Haven’t run it yet, but Maslow should be able to process it.
3 Likes