Mark chains sprockets 12 oclock

[Carlos_Delgado]

Hello everyone, I got an excellent configuration and I want to save it. I understand that I should keep a backup of the ini file. and mark the chais during the initial calibration process when the sprockets are at 12, well, this I didn’t. Is there a way to return the sled to this point to mark them?

[Metalmaslow]

How To: Manually Reset Chains, the Easy Way

Every now and then you may find that you need to readjust the chains back to a known position. This could occur if you power/connection issue and the controller lost it’s position, had a chain skip, took apart something for some reason, etc… Fortunately, there’s a way to reset the chains without a lot of work. During calibration, after you set the sprockets vertical, you extend the chains out to reconnect to the sled. If your “Extend Chain Distance” is a multiple of a full revolution of the s…

[Metalmaslow]

so accoriding to above I would set sprockets vertical with sled in middle of the board. maybe even drill a hole in the waste board and mark it and then paint the chain link

[kayaker37]

Web control has a tab called check for chain skip which puts it back in position.