PCB Mount for DeWalt 26200 - Yet Another Version
Folks, this is my spin on the PCB mount for the DeWalt 26200 which has a slightly different mounting pattern for us East-Pondians.
This is based on the footprint created by @geertdoornbos here but I wanted to rotate it slightly to avoid the clash with the power cable on the router. I was too lazy to do the neat fitted version which may result in a debris trap but time will tell.
One thing to note, the mounting post circled in the image below is behind the power cable on the router and this makes it a bit awkward to access. If I could be bothered to print it again I’d probably rotate it (the angle is a parametric value in the Fusion 360 file) so the PCB power connector is on the other side of the router power cable Ignore this, I just realised the router power cable would then block the stepper motor connectors.
PCB Holder DeWalt D26200 TG Remix v3.f3d (728.2 KB)
PCB Holder DeWalt D26200 TG Remix v3.step (295.9 KB)
PCB Holder DeWalt D26200 TG Remix v3.stl (1.6 MB)
Hope this is of some use to someone