Can the Maslow save belt positions?

Troubleshooting
1

I’m setting my Maslow up on a table where one of the corners is hard to get to. So ideally I’d like to just leave it there with at least that belt extended. If I have to take all the belts off the posts, then retract/extend and put them back on every time the machine power cycles, that adds a noticeable chunk of time and difficulty. Is it OK to leave it turned on for days or weeks at a time, or can it somehow save that position?

I know that this is fairly minor, but maybe there’s some trick I’m overlooking. Thanks all!

2

For the later versions, you can power down while in ready to cut status and on powering back up select ApplyTension, and it should go to ready to cut
You have to leave the belts extended on the anchors for this to work.
You can also release tension then disconect belts to make it easier to replace work material then Apply Tension to get back to ready to cut

2 Likes
3

Thanks! I will try that.