Command line utility to 'clean' GCode

[md8n]

GCodeClean hits v1.0.1

GCodeClean hits v1.0.2 This release ‘kind of’ adds the file pre-scan from the road map above. What I did in the end was to split the processing into 3 phases, with the first phase leaving the GCode in a position where it could be reliably ‘scanned’ to get the length units (inches or millimeters). And with that the code can then constrain the tolerance and clamping values. Release v1.0.2 - Pre-scan · md8n/GCodeClean (github.com)