I would suggest yes, but before you do, try lowering the Retraction Force and Calibration Force to 900 and confirm the belts Extend and Retract. It should be possible after tuning the spools.
If you have access to a 3d printer, check out the Maslow 4 3D printed parts thread, there are a couple of options to print replacement clamps and other useful things. I had the same problem and printed a replacement for the lower clamp.
With you anchor points you need some sort of support, 3D printed or a block of wood, Bolts, by themselves, tend to bend and won’t give you a reliable anchor point, especially when Maslow is getting close to corners.
2 Likes