SOLD - Maslow 4.1 with DeWalt Router in Bellingham, WA

Swap Meet
1

Selling my fully assembled and working M4.1 with DeWalt router and spare parts. I was an early supporter of the original Kickstarter for the M4, and again for the 4.1 upgrade campaign. I used this machine for a few projects over the span of a couple years before deciding that I wanted to upgrade to a gantry style machine. The router was purchased for use in the M4, and is in like-new condition with less than 25 hours of run time. Selling the machine with router for $500, or $400 without the router.

I am located in Bellingham, Washington…about half way between Seattle and Vancouver, B.C. I would be willing to drive down to Marysville to meet a buyer from the Seattle area, or up to White Rock or Abbotsford, B.C. to meet a buyer from the Vancouver Metro Area. I would also be willing to ship domestically to the lower 48 states- I have no idea how much shipping would be, but probably between $50-$100 with the router.

Anyone interested can message me here, or text me at 360-two zero seven-1977 with questions.

Thanks,
Eric

Maslow4
Maslow4756×1008 255 KB

Spare Parts
Spare Parts998×1331 388 KB

ski rack cutting
ski rack cutting600×800 137 KB

rod holder cutting
rod holder cutting600×800 153 KB

2 Likes
2

Hi Eric,

I’m in Bellingham and want to buy your machine. Do you still have it? If so, I’ll message you.

Thanks!

Graham

3

Message sent.

4

Sold my Maslow, and met a new neighbor…the buyer lives only a couple blocks down from us on the same street! Looking forward to getting to know him and geeking out about CNC woodworking.

Thanks to all of the creative and smart people here in the forums who helped and inspired me along the way. I wish everyone in this amazing community all the best!

2 Likes