Z axis & Motor Calibration

jwolter Split this topic June 10, 2018, 2:30am 20

10 posts were merged into an existing topic: Maslow Chain Geometry Spreadsheet

Topic		Replies	Views
Solved: Stuck on Z-axis calibration step during initial setup Ground Control calibration	26	2516	August 2, 2018
Problem executing calibration while executing calibration Troubleshooting	19	1099	June 17, 2019
Motors moving opposite direction of what they should? Troubleshooting groundcontrol	17	1890	March 28, 2018
[Solved] GC 1.11 strange results during calibration Troubleshooting	34	1870	April 9, 2018
Z-Axis tries to go through the roof/top plate of the axis Troubleshooting	18	895	March 18, 2020