I got a successful calibration on the 2nd attempt. Even the first attempt was way better than any previous attempt.
On the first attempt, it made it through the initial 5 point calibration and then the 3x3 but got stuck on the 5x5. EVERY previous calibration had failed on this initial 5 point calibration.
On the second attempt, it made it all the way through and saved everything the to maslow.yaml file, which I immediately backed up!!
I think the only step that was different in the video vs what I had been doing is…
Before starting calibration, pull the sled so that the Tl and Tr belts are tight
I’m pretty excited to get started on a few test cuts!! Thanks again to @bar and @dlang for your help. I’m sure I’ll have more questions, but I’m feeling good about the progress so far!