Bar's Bits and pieces

Has anybody bought the Maslow manufactured bits? What do you think of them? Haven’t seen anybody commenting on them yet.

I’m especially interested in the compression bit and how it does with chipout. The picture doesn’t give much of an idea of how far the up and down areas are, or what depth of cut will get into the downcut section.

2 Likes

I’ve got one of the compression bits but haven’t used it yet. It looks like 1cm up, a little more than than down.

Not sure of the best use for these - in a cleanup pass as the last time around, maybe?

1 Like

Just got my bits today. … looking forward to trying them before long.

1 Like

Well… I burned one up cutting out my chair. Not 100‰ of the reason though.

Last pass was more burning than cutting.

What was the spindle speed/feedrate?

1 Like